Brake Lines pt 2

Next up the brake lines to the rear inboard discs. Same as the front a 3way union is used to split the rear line for the two callipers.

An m6 set screw tapped an bolted to the chassis. 

Bend both pipes to suit positions

A bit more bending and fitting and then the pipe can have a pipe clip fitted as below.

Next up the long run between front and rear - I will have to wait until I'm ready to lift the engine out for that as it's impossible to drill the fittings even with the right angle drill adapter.

I need to start thinking about the fuel run too as this will need doing at the same time.